WebMay 7, 2024 · Here’s how we would mount our encrypted partition to the /mnt/encrypted folder. # cryptsetup --type luks open /dev/sdb encrypted # mount -t ext4 /dev/mapper/encrypted /mnt/encrypted To unmount the encrypted partition, we’d use the following two commands which will also close the mapped device. # umount … WebFeb 8, 2024 · Registered: 2014-05-14 Posts: 105 Hi! I have a LVM on LUKS on a RAID1 array I can't close ~ $ cryptsetup luksOpen /dev/md0 raid ~ $ cryptsetup luksClose /dev/mapper/raid Command failed with code -5 (device already exists or device is busy). Device /dev/mapper/raid is still in use. Any ideas?
cryptsetup / cryptsetup · GitLab
WebFirst make sure the partition is empty (has no file system attached to it). Delete the partition and create an empty one if it has a file system. Then prepare the partition by securely erasing it, see Dm-crypt/Drive preparation#Secure erasure of the hard disk drive. Create the partition which will contain the encrypted container. city named after athena
[SOLVED] Can
Webcryptsetup is used to conveniently setup dm-crypt managed device-mapper mappings. These include plain dm-crypt volumes and LUKS volumes. The difference is that LUKS … Webcryptsetup cannot close mapped device. LANG=C cryptsetup --debug luksClose /dev/mapper/Pool-A it fails as follows: device-mapper: remove ioctl on Pool-A failed: … WebMar 20, 2015 · However, if the device argument is a file, cryptsetup tries to allocate a loopback device and map it into this file. This mode requires Linux kernel 2.6.25 or more recent which supports the loop autoclear flag (loop device is cleared on last close automatically). Of course, you can always map a file to a loop-device manually. city named gay